Hello
I use JCE many years an since 2 or 3 versions there is a bug in the editor.
If I open an article and the tab is "code" then I have the correct syntax for "php start" and "php end" picture jce_11.jpg
afterwards I switch the tab to "Editor" and back to "code" then JCE change the code inside the i-frame - definition picture JCE_12.jpg
Best regards
Peter
I use JCE many years an since 2 or 3 versions there is a bug in the editor.
If I open an article and the tab is "code" then I have the correct syntax for "php start" and "php end" picture jce_11.jpg
afterwards I switch the tab to "Editor" and back to "code" then JCE change the code inside the i-frame - definition picture JCE_12.jpg
Best regards
Peter
Ryan
marked this post as Resolved — 1 year ago
Thank You Ryan
The editor-parameter was setting to NO before, but I install the new version 2.9.30 and its correct now.
Best regards
Peter
The editor-parameter was setting to NO before, but I install the new version 2.9.30 and its correct now.
Best regards
Peter
Please try JCE Pro 2.9.30 RC2 - https://www.joomlacontenteditor.net/downloads/editor/pro/development
Just because you're not paranoid doesn't mean everybody isn't out to get you.
In Editor Profiles -> Editor Parameters -> Advanced, set Protect Shortcode to No.
Just because you're not paranoid doesn't mean everybody isn't out to get you.
Please try JCE Pro 2.9.30 RC - https://www.joomlacontenteditor.net/downloads/editor/pro/development
Clear your browser cache after install.
Clear your browser cache after install.
Just because you're not paranoid doesn't mean everybody isn't out to get you.
- Page :
- 1
There are no replies made for this post yet.
Be one of the first to reply to this post!
Be one of the first to reply to this post!